fantasticmio.com

I’d been thinking about making these hats for a while, stymied by a lack of the right colours.

I happened to be at Michaels one day and noticed that Vanna’s Choice yarn had the perfect colours! Not knowing how much I’d need, I naturally over-bought… just in case.

And so I present to you: how to wing an R2D2 hat!

First, start with a sketch:

Next, decide how big around you want the hat to be. I figured 20″ would do the trick, so I did a foundation-dc row about that long, trying (successfully) to get a number of stitches that were evenly divisible by 12 (ended up with 60).

Now, I made the first hat working from the bottom up, then, now having the pattern, I made the next one working top down. (And then had to make a third one because the second one was too big for me and my abnormally large head).

The basic pattern is as follows (from top down) :
R1: 12 dc
R2: 24 dc
R3: 36 dc
R5: 48 dc
R6: 60 dc
All following rounds: 60 dc.

13 or 14 rounds should do it for a kid’s hat. For an adult, do some increases on R7, but take my advice: adding 6 more stitches is too many! :P

Basically, just plug the colours in as per the sketch!

The final step is to make that eye thingie… with black, do a round of 12dc. Then a round of *5dc, hdc, hdc* four times in blue and sew it on.

Of course, I had to make scarves to go with them!

They’re about 3.5 feet long… I think…

This one used post stitches (both dc and tr)

This one used back-loop-only dc stitches:

The green part worked out even better than I thought it would.

I started with a row of foundation dc stitches approximately 3 feet long. Then I did 5 dc stitches into the base of the last foundation dc, then did 1 dc stitch into the bottom of each foundation dc that followed until I had worked into all of them.

Next was a turning chain, 1dc in each stitch until the rounded end, where I did 2dc in each of the 6 stitches making up the rounded end. Then 1 dc in each stitch until the end.

Turning chain, 1dc in each stitch until the rounded end. Then *2dc, 1dc* 6 times to get around the end, then 1dc in each stitch.

Turning chain, 1dc in each stitch, *2dc, 1dc, 1dc* 6 times to get around the end, 1dc in each.

When I got to the flat end this time, I did ch1, then worked sc stitches along the flat edge, basically working 2 sc into the side of each dc, plus an extra one right in the centre.

I then switched to grey and made up the hilts as I went along. If you’re not comfortable with this, a nice, simple hilt could be made by working a dc in the back loop only into each stitch, for as many rows as you think look nice.

Rounded end:

I just love how well working into the bottom of the foundation stitches worked! I think it looks really smart. I’m going to have to use this technique again!

Check out the adorableness: